Implementing Character LCD Device Driver Development on LPC2148 ARM Based 32-Bit Micr

[naveen]

Implementing Character LCD Device Driver Development on LPC2148 ARM Based 32-Bit Microcontroller

This project is designed to interface 16 X 2 character LCD to ARM based microcontroller. Data entry is through PC’s hyper terminal and the received data is displayed on LCD. MAX 232 is used to communicate with the hyperterminal.

The LPC2148 are based on a 16/32 bit ARM7TDMI-S™ CPU with real-time emulation and embedded trace support, together with 128/512 kilobytes (kB) of embedded high speed flash memory. A 128-bit wide memory interface and a unique accelerator architecture enable 32-bit code execution at maximum clock rate. For critical code size applications, the alternative 16-bit Thumb Mode reduces code by more than 30% with minimal performance penalty. With their compact 64 pin package, low power consumption, various 32-bit timers, 4- channel 10-bit ADC, USB PORT,PWM channels and 46 GPIO lines with up to 9 external interrupt pins these microcontrollers are particularly suitable for industrial control, medical systems, access control and point-of-sale. With a wide range of serial communications interfaces, they are also very well suited for communication gateways, protocol converters and embedded soft modems as well as many other general-purpose applications.

This project uses two power supplies, one is regulated 5V for modules and other one is 3.3V for microcontroller. 7805 three terminal voltage regulator is used for voltage regulation. Bridge type full wave rectifier is used to rectify the ac out put of secondary of 230/12V step down transformer.


Find The Attached Doc Below.....

[mathe.prasad]

Plz send me this project documentation or ppt to my email id..and my email id is prasad.mathe0@gmail.com

(11-22-2010 07:13 PM)naveen Wrote:  Implementing Character LCD Device Driver Development on LPC2148 ARM Based 32-Bit Microcontroller

This project is designed to interface 16 X 2 character LCD to ARM based microcontroller. Data entry is through PC’s hyper terminal and the received data is displayed on LCD. MAX 232 is used to communicate with the hyperterminal.

The LPC2148 are based on a 16/32 bit ARM7TDMI-S™ CPU with real-time emulation and embedded trace support, together with 128/512 kilobytes (kB) of embedded high speed flash memory. A 128-bit wide memory interface and a unique accelerator architecture enable 32-bit code execution at maximum clock rate. For critical code size applications, the alternative 16-bit Thumb Mode reduces code by more than 30% with minimal performance penalty. With their compact 64 pin package, low power consumption, various 32-bit timers, 4- channel 10-bit ADC, USB PORT,PWM channels and 46 GPIO lines with up to 9 external interrupt pins these microcontrollers are particularly suitable for industrial control, medical systems, access control and point-of-sale. With a wide range of serial communications interfaces, they are also very well suited for communication gateways, protocol converters and embedded soft modems as well as many other general-purpose applications.

This project uses two power supplies, one is regulated 5V for modules and other one is 3.3V for microcontroller. 7805 three terminal voltage regulator is used for voltage regulation. Bridge type full wave rectifier is used to rectify the ac out put of secondary of 230/12V step down transformer.


Find The Attached Doc Below.....